Driveways and paths · County Tyrone

New tarmac driveways in Cookstown

Planning a new tarmac driveway in Cookstown? We'll measure up, look at the edges and drainage, and set the specification out in writing before you commit to anything.

COOKSTOWN GUIDE£53–£84 per m² inc VAT
Wide new tarmac driveway with granite sett border leading to a garage, typical of new tarmac driveway work

What does a new tarmac driveway cost in Cookstown?

For Cookstown, we apply the Northern Ireland rate, about 12% below our UK midpoint. Your survey turns these ranges into a fixed price.

ItemGuide price (inc VAT)
New black tarmac drive, full dig-out and new sub-base£53–£84 per m²
Example: 30 m² drive£1,750–£2,750
Example: 50 m² drive£2,650–£4,200
Example: 80 m² drive£4,200–£6,700

As a 2026 guide in Cookstown, new tarmac driveway work runs at about £53–£84 per m² including VAT, so a 80 m² drive is roughly £4,200–£6,700. Guide only; the survey confirms a fixed price.

Covering Cookstown

Cookstown at a glance. Cookstown is covered on our County Tyrone rounds, 22 miles from Omagh.

Postcodes
BT80
Area
County Tyrone
Nearest towns
Coalisland (7 miles), Magherafelt (9 miles), Dungannon (10 miles), Omagh (22 miles)
Pricing
Northern Ireland, about 12% below our UK midpoint
Kerb approvals
DfI Roads

We also cover nearby Coalisland, Magherafelt, Dungannon, Omagh.

What the price covers

A new tarmac driveway is built from the ground up: the old surface and soil are dug out, a compacted stone sub-base is laid, then a hot binder course and a finer surface course are spread and rolled, and the edges are held by kerbs or blocks.

  • Break out and remove the old surface and spoil
  • Geotextile membrane where the ground is soft or clay
  • Concrete-haunched kerbs or a block-paved border as edge restraint
  • Surface course (AC 6 dense), about 20–30 mm, laid hot and rolled
  • Falls set so water runs to a channel, gully or soft landscaping

Rules that apply in Cookstown

In Northern Ireland, the Planning (General Permitted Development) Order (Northern Ireland) 2015 allows a hard surface between the front of a house and a road without permission if it is porous or drains to a porous area within the property, once it exceeds 5 m². Listed buildings and some access changes need permission. Any new or altered vehicle access onto a public road needs approval from DfI Roads, not the council.

Questions about new tarmac driveways in Cookstown

Do you cover all of Cookstown?

We cover Cookstown including BT80, and nearby Coalisland, Magherafelt, Dungannon.

Will someone visit before I get a fixed price in Cookstown?

Yes for new surfacing such as drives, paths, private roads and car parks. Small repairs are often priced from photos; if a visit is needed for a repair-only job, we tell you any charge first.

What is the price of a new tarmac driveway in Cookstown?

As a 2026 guide in Cookstown, new tarmac driveway work runs at about £53–£84 per m² including VAT, so a 80 m² drive is roughly £4,200–£6,700. Edging, drainage and a dropped kerb are priced separately where needed.

What approvals apply in Cookstown?

In Northern Ireland, more than 5 m² of hard surface in front of a house should be porous or drain to a porous area within the property; DfI Roads approves dropped kerbs. Dropped kerbs are approved by DfI Roads.

More we do in Cookstown

Questions about new tarmac driveways in Cookstown? Call, WhatsApp or use the form, and we'll talk it through.

Free survey for new surfacing

New tarmac driveways in Cookstown: get a written quote

Send a postcode and a rough size and we'll arrange a survey. Every quote lists the layers, edging, drainage and VAT.

  • Surface courseDEPTH + MIX
  • Binder courseDEPTH + MIX
  • Sub-baseDEPTH + MATERIAL
  • Edges, drainage, VATITEMISED
Call nowGet a price